Dell™ PowerConnect™ / is provided with pre-defined not set to auto -negotiation, both the switching port and the NIC must be manually set with the. Office Manuals and free pdf instructions. Find the office and computer equipment manual you need at ManualsOnline. Dell Switch User Manual. Page 1. Manufacturer: Dell, Model: , Type of document: User manual, Category: Switch, Number of pages:
|Published (Last):||12 December 2005|
|PDF File Size:||11.99 Mb|
|ePub File Size:||2.72 Mb|
|Price:||Free* [*Free Regsitration Required]|
Configures the maximum broadcast rate.
The rules should oblige the seller to give the purchaser an operating instrucion of Dellalong with an item. Configures the spanning tree port cost for a port.
Page CLI Command management access-list name permit [ethernet interface- number vlan vlan-id port- channel number] [service service] permit ip-source ip-address [mask mask prefix-length] [ethernet interface-number vlan vlan-id port-channel number] [service service] deny [ethernet interface- number vlan vlan-id port- channel number] [service service] deny ip-source ip-address Manuall Authentication Profiles The rule is added, and the device is updated.
Line protocol on I[ Open the Copy Files page.
To configure user name poowerconnect privilege level, enter the command at the system prompt as shown in the configuration example:. The Image file is selected.
Defining Dhcp Ip Interfaces Defining Vlan Ports Settings Aging time is sec vlan mac address port type If a previously entered configuration causes problems, the startup-configuration file configuration of device when powered up should be erased and device cell, see ” Device Default Settings “. Viewing Lag Statistics Added Functionality In This Release Page — SNMP Admin—Indicates that the user powerconnct access to all device configuration options, as well to modifying the poowerconnect.
To open the Mapping to Queue page: Configuring Port Security CLI Command show gvrp error-statistics [ethernet interface port-channel port- channel-number] he following is an example of the CLI commands: CLI Command wrr-queue bandwidth weight1 weight2. The port parameters are saved to the device. Flash file name 8 characters, Enter for none.
Dell manual – BKManuals
Problems With Your Order The Access Profiles page contains the following fields: Mapping Cos Values To Powerconhect The initial configuration scope for the device includes:. MAC addresses are dynamically learned as packets from sources arrive at the switch.
Enter the command Telnet and the device IP address. Configuring Switch Infor m ation Viewing Counter Summary The Counter Summary page contains statistics for port utilization in numeric sums as opposed to percentages. Page 83 Ensure that an IP address is assigned to at least one port on the Master unit.
Contents 3 Contents 1 Over view System Description. Assigning access rights to a user: Page 50 Gateway IP Address IP Address Configuring System Information — Wa r n i n g —Indicates the lowest level of a device wa[ Device Setup Requirements Defining General Device Information This section provides information about defining system parameters including security features, downloading device software, and resetting the device.
The configured gateway IP address must belong to the same subnet as one of the device IP interfaces.
Configuring the PowerConnect 3324/3348 Switch
Replacing Stack Members Page V e r s i o n s P a g e The Versions page contains the following information: Displays port lock status. If enabled, the LAG State determines what forwarding action is taken on traffic.
CLI Command wrr-queue cos-map queue-id cos1. The Local User Table page opens.
To continue using , please upgrade your browser.
Customer Service Austin, Texas, U. Kitts and Nevis General Support St. Unit SW version 1.
Defining Device Events If possible, turn on your system before you call Dell for technical assistance and call from a telephone at or near the computer.